You are here: start » pcboard



To load PCBoard, type BOARD at the DOS command prompt. This will execute the BOARD.BAT that is installed in your \PCB directory. When PCBoard is loaded, it will present the call waiting screen to you.

The first part of this chapter discusses the call-waiting screen. The rest of the sections in this chapter discuss the command line parameters and switches you can use to load PCBoard, the status line, and potential problems that you can run into while attempting to load PCBoard.

Table of contents

pcboard/start.txt · Last modified: 2019/04/16 16:07
CC Attribution 4.0 International Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution 4.0 International